Visit our discussion site!
George
Nov-21-14 0 Hits


My apoligies to anyone who attempted to contact me about this listing and I did not respond. I was in an auto accident and have been in recovery for a long time. But I'm back now and still looking for the barrel listed below. 

I am looking for a 1914 Colt government model barrel to complete my "canadian contract" 1911. From my research and advice from others I believe the correct barrel would be blued and have a "P" proof on the top but no "H". Also there would be a 5 or an S stamped just in front of the bottom lugs and possibly inspectors stamps on the side of one or both of the bottom lugs. The one example ive seen (again I beleive this is the correct barrel) had a "C" stamped on the right side bottom lug. Will consider any condition. 

Please contact me at 3865031741 or email me at yorge9003@aol.com 

Thank you.

Florida


  Send Message   Phone: 3865031741

Related ads

Union Switch & Signal Du-lite stamped trigger

I have what has been told to me to be an Union Switch & Signal  Du-lite stamped trigger. Looks to be in good condition. I will get pictures of it in a little bit.  $100 shipped. PAYPAL preferred.   EARRNHARDT3@AOL.COM 

Frame parts (Slide stop/thumb safety/msh/hammers)

For sale are WW1 frame parts. Triggers, mainspring housing assembly and internals, slide stop, thumb safety, hammers, ejectors, sear, disconnectors, and sear spring. Mainspring housing - $70 (3 left)     Slide Stop - $90    Thumb Safety - $70 (1 left)…

Wanted: Colt 1911 U.S. Army type 1 magazine

I am looking for a Colt 1911 U.S. Army Type 1 Magazine. If you have one or know where i could find one please let me know. 

1911a1 WW2 era General Shaver magazine

For sale is this 1911a1 WW2 era General Shaver magazine.  This magazine is in good condition, as the photos show some bluing has worn off of the bottom.  The General Shaver magazine is typically associated with the Remington Rand 1911a1's due to their…

For Sale Remington UMC 1911 Slide

Complete slide with original finish. No rust or pitting. Don't know if firing pin assembly and extractor are original or not. I put slide on one of my 1911a1 frames and fired a couple of magazines. Fit and function was fine. Asking $250.00 plus $8.00…

Report this ad

Stats

206628 views

803 ads

14983 users

Subscribe

Share